What are the requirements for the design, service and inspection items of automobile inspection line?
automobile The detection line is mainly used for the routine inspection of electric vehicles, which can ensure that the vehicle can avoid faults in the process of use. What are the aspects?
1. The detection line is used to check the speedometer.
2. Front wheel brake force test.
3. Rear wheel brake force test.
4. High speed test.
5. Relative deviation test of front and rear wheel center plane.
6. Starting acceleration test.
7. Test the acceleration of line pairs.
8. Axle load test.
9. Headlamp luminous intensity and illumination position test.
10. Idle exhaust emission test.
11. Horn sound level test.
Through the further understanding of the detection line and the detection of its various items, we can have a more in-depth understanding of the overall performance and running speed of the electric vehicle, so as to ensure that it can ensure absolute safety in normal driving, and also provide users with more reassurance when using electric vehicles.
The use and arrangement of vehicle detection line should be in the place with comprehensive vehicle environmental protection inspection and automation and information operation service ability, and it should be an organization that can provide network information transmission service. Such place has many professional requirements, and its design and service requirements are as follows:
The inspection sites shall be reasonably arranged within a certain area according to the planning formulated by the provincial and municipal environmental protection administrative departments. The site selection of the inspection sites shall be in a convenient location for vehicle inspection. The inspection site shall meet the requirements of relevant environmental protection laws, regulations and standards to avoid adverse effects on the surrounding environment. For heavy vehicle testing, the passing height of the inspection workshop shall not be less than 4.5 m; for the light vehicle test line, the passing height of the inspection workshop shall not be less than 3.5 M. The width of the motorway entering the inspection workshop shall not be less than 5 meters. The inspection site is generally composed of inspection workshop, reception area and outdoor automobile road. The inspection place shall have inspection procedure notice board and charge notice board. The charge notice board shall list the test items, detection methods, limit standards and charging standards for various types of motor vehicles. The site of the inspection site should be hard ground and flat, with obvious guide signs.
In addition, it is also important that our vehicle detection line should be equipped with communication facilities for information exchange between driving operator and detection system operator, and emergency button should be installed at appropriate position, through which the detection system operator can warn the driving operator to stop detection and turn off the detection power supply.